Mitutoyo-SERIES 511 – ABSOLUTE Digimatic Bore Gages-Bore Gages

• These ABSOLUTE Digimatic bore gages are exclusively designed for inside diameter measurement.
• Up to four extension rods (250mm or 500mm) can be used for measuring at the bottom of a hole 2m deep.
• ABS (ABSOLUTE) type bore gages are not subject to overspeed error.
• The display and grip can be rotated up to 320 degrees and the display can be inclined up to 90 degrees, so that it is easily readable from any direction.
• The minimum value holding function provides easy measurement of hole diameter.
• Setting the Bore Gage to a master value using a gauge block set allows quick and accurate setting.
• A Bore Gage Checker and a range of Setting Rings are available to aid in accurately setting a gage before making a measurement. (For details, refer to pages C-46 and C-47.)

SPECIFICATIONS

Metric

Inch

Notes: 1) Normal use is assumed to be 8 hours per day.
2) The correct peak value may not be displayed if the anvil’s speed exceeds 50 μm/s.
3) IP53 indicates resistance to dust and dripping water, but only applies when the connector cap is in place.

DIMENSIONS

STANDARD ACCESSORIES

Technical Data
Accuracy: Metric models 3µm
Inch models .00012″
Excluding quantizing  error
Repeatability: Metric models 2µm
Inch models .00008″
Adjacent error: Metric models 2µm
Inch models .00008″
Battery: SR44 (2 pc), 938882,  for initial operational checks  (standard accessory)
Battery life: Approx. 2000 hours under normal use.
Display: LCD character hight 8.5mm
Scale type:   ABSOLUTE electrostatic linear encoder
Max. response speed: Unlimited

Function
Preset function
Master value registration (3 values at maximum)
Tolerance judgment
Upper/lower limit registration (3 values at maximum)
Minimum value holding
Data output
Display rotation (320°)
Display inclination (90°, 7 steps)
Low battery alarm display
Error display

Optional Accessories
21DZA089:  Extension rod 250 mm (10″)
21DZA081:  Extension rod 500 mm (20″)
Up to four extension rods can be jointed, and the
maximum length 2m is allowed.
Refer to page A-21 for details
Connecting  cables for Input Tool/ Digimatic Mini-Processor, etc.
1m: 905338
2m: 905409

USB Input Tool Direct (2m): 06ADV380F
Connecting cables for U-WAVE-T
For standard  (160mm): 02AZD790F
For foot switch: 02AZE140F
— : Setting ring (See page C-47.)
Digimatic Mini-Processor DP-1VR: 264-504

Example of connection
When connecting four pieces of 500mm extension rods

Gauge blocks and block sets for setting the origin or master value (optional)

Rectangular gauge blocks
* Available only for 511-501/521
516-118-10
516-118-60 with calibration certificate

* Equivalent to JIS B 7506 Grade 0

Square gauge blocks
* Available only for 511-501/521
516-119-10
516-119-60 with calibration certificate

* Equivalent to JIS B 7506 Grade 0